![]() Switch: boot flash.binĪfter the Xmodem recovery, we set the BAUD rate back to 9600. Switch:copy xmodem: flash.binīegin the Xmodem or Xmodem-1K transfer now.Īnd start sending of the file over console Xmodem software.Īnd then you choose as protocol the Xmodem and in filename click Browse and select the Cisco IOS image (.bin file) from the disk to be uploaded.Īfter the image was uploaded you need t o boot the new image that you just copied over with the Xmodem procedure issue the boot flash:filename command, as the example shows: Of course you lose your console session and therefore you need to restart it with the correct speed settings. Set the speed rate to 115200 baud on the switch prompt of the switch: To speed up the process of the recovery we may setup Xmodem speed to higher rate as default 9600 bits: ![]() Unfortunately switches does not have rommon to realize quick IOS recovery over tftp. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |